Spreader adjustment for the nitrogen fertilizer Extra-Power

Depending on the existing model, a different setting must be selected for the application of Turbogreen Extra-Power. The recommended application rate is a maximum of 20 g/m². Our settings are based on customer feedback and are therefore constantly being improved;

Attention: These settings apply only for the Turbogreen Extra Power!

Turbogreen: Setting:Turbogreen Spreader → Level 4

You should always be very careful when using a spreader wagon to apply Turbogreen Extra Power. We recommend measuring the exact amount for the lawn before application and making sure that it is evenly distributed. After application, it is important to water the lawn well. A quantity of 12 liters of water per square meter is recommended.

This will tell you the correct level for your spreader wagon:

Mark out an area of 1 m² on a flat surface (optionally, a film can be laid out on the surface). Spread the grit on this area with the spreader wagon, then sweep it up again and weigh it. If it is approx. 20 g, then the setting is correct. If it is too much or too little, optimize the level.

Spreader settings of other brands:
The following spreader settings are based on customer experience and have not been officially tested. Please check and adjust them before use (use at your own risk).

Brand and Model: Setting:

• Gardena L → Level 2-3

• Gardena 415 → Level 2

• Gardena Classic 300 → Level 2-3

• Gardena XL plate spreader → Level 3

• Wolf battery-powered hand spreader → Level 3

• Wolf WE 330 → Level 5

• Wolf WE 430 → Level 9-10

• Substral EasyGreen universal centrifugal broadcaster → Level 19-20

If you find an optimal setting for your spreader, we would be very pleased if you could pass on the relevant information about the model of your spreader wagon and the setting to us so that we can include it here. Unfortunately, there are so many different spreader settings that we cannot test them all.